Exam Description: Securing Networks with Cisco Firepower v1.0 (SNCF 300-710) is a 90-minute exam associated with the CCNP Security Certification. This exam tests a candidate's knowledge of Cisco Firepower® Threat Defense and Firepower®, including policy configurations, integrations, deployments, management and troubleshooting. These courses, Securing Networks with Cisco Firepower, and Securing Networks with Cisco Firepower Next-Generation Intrusion Prevention System helps candidates prepare for this exam.
The following topics are general guidelines for the content likely to be included on the exam. However, other related topics may also appear on any specific delivery of the exam. To better reflect the contents of the exam and for clarity purposes, the guidelines below may change at any time without notice.
1. Deployment(30%)
2. Configuration(30%)
3. Management and Troubleshooting(25%)
4. Integration(15%)
LABS:
Lab 1: Cisco NGFWv and NGIPSv Device Installation
Lab 2: Cisco Firepower Management Center virtual Installation
Lab 3: Firepower Device Manager - Introduction
Lab 4: Firepower Device Manager - Configuration
Lab 5: Navigate the Cisco Firepower Management Center GUI
Lab 6: FMC Web Interface and New Features
Lab 7: Device Registration and Smart Licensing
Lab 8: Device Management: Basic Configuration
Lab 9: Firewall Mode and Interface Type
Lab 10: Routing - Static and BGP
Lab 11: Routing - OSPF
Lab 12: IPv6 configuration
Lab 13: Implementing Network Address Translation (NAT)
Lab 14: Implementing QoS
Lab 15: Implementing Multicast
Lab 16: Configuring Network Discovery
Lab 17: Implementing an Access Control Policy
Lab 18: Implementing SSL Policy
Lab 19: Implementing Application Filtering
Lab 20: Implementing Custom Application Filter
Lab 21: Implementing Compliance Enforcement with Whitelist
Lab 22: Implementing Event Correlation & Remediation
Lab 23: Implementing Traffic Profile
Lab 24: Implementing Active and Passive Authentication
Lab 25: Implementing Security Intelligence
Lab 26: Implementing File Policy
Lab 27: Implementing AMP for Networks Malware Protection
Lab 28: NGIPSv IDS and IPS Modes
Lab 29: Implementing NGIPS Policy Layers
Lab 30: Implementing NGIPS Firepower Recommoneded Rules
Lab 31: Implementing NGIPS Rules and Rule actions
Lab 32: Implementing NGIPS Custom Rules
Lab 33: Implementing Prefilter Policy
Lab 34: Implementing Flexconfig
Lab 35: Implementing Safesearch
Lab 36: Implementing Inline SGT
Lab 37: Implementing ISE Remediation
Lab 38: Implementing Site-to-Site VPN
Lab 39: Implementing High Availability (HA)
Lab 40: Implementing Multi Domain Management
Lab 41: Performing Detailed Analysis and Reporting
Lab 42: System Administration
Lab 43: Firepower Troubleshooting